#Rec tube bypass code code#

Soldered, Brazed, Threaded, or Mechanicalġ-1/2 inches and smaller, 6 feet 2 inches and larger, 10 feetģ/4 inch and smaller, 10 feet 1 inch and larger, 12 feetĮvery other floor, not to exceed 25 feet 5ġ/2 inch, 6 feet 3/4 inch and 1 inch, 8 feet 1-1/4 inches and larger, 10 feetġ/2 inch, 6 feet 3/4 inch and 1 inch, 8 feet 1-1/4 inches every floor levelĪll sizes, 4 feet allow for expansion every 30 feet 3,6īase and each floor provide mid-story guides provide for expansion every 30 feet 6ġ inch and smaller, 3 feet 1-1/4 inches and larger, 4 feetīase and each floor provide mid-story guidesġ/2 inch, 5 feet 3/4 inch, 65 inches 1 inch, 6 feet Table 313.3 is amended to read as follows: TABLE 313.3ĥ feet, except 10 feet where 10 foot lengths are installed 1,2,3īase and each floor, not to exceed 15 feetĮvery other joint, unless over 4 feet then support each joint 1,2,3Įvery other joint, unless over 4 feet then support each joint 1,2,3,4

#Rec tube bypass code code#

An alternate material or method of construction so approved shall not be considered as in accordance with the requirements, intent, or both of this Code for a purpose other than that granted by the Authority Having Jurisdiction where the submitted data does not prove equivalency. However, the exercise of this discretionary approval by the Authority Having Jurisdiction shall have no effect beyond the jurisdictional boundaries of the Authority Having Jurisdiction. Unless prohibited by this code or by law, the Authority Having Jurisdiction shall have the authority to approve or disapprove the system, method, or device for the intended purpose. Prior to installation, technical documentation shall be submitted to the Authority Having Jurisdiction to demonstrate equivalency. Nothing in this code is intended to prevent the use of systems, methods, or devices of equivalent or superior quality, strength, fire resistance, effectiveness, durability, and safety over those prescribed by this code.

UPC section 301.3 is amended to read as follows:ģ01.3 Alternate Materials and Methods of Construction Equivalency. SIZE OF LEADERS, CONDUCTORS, AND STORM DRAINS. SLAUGHTERHOUSES, PACKING ESTABLISHMENTS, ETC. INTERCEPTORS (CLARIFIERS) AND SEPARATORS. STEAM AND HOT WATER DRAINAGE CONDENSERS AND SUMPS. MULTIPURPOSE POTABLE WATER PIPING SYSTEMS.ĭRAINAGE OF FIXTURES LOCATED BELOW THE NEXT UPSTREAM MANHOLE OR BELOW THE MAIN SEWER LEVEL.ĭAMAGE TO PUBLIC SEWER OR PRIVATE SEWAGE DISPOSAL SYSTEM.ĪBANDONED SEWERS AND SEWAGE DISPOSAL FACILITIES. INSTALLATION, TESTING, UNIONS, AND LOCATION.

WATER PRESSURE, PRESSURE REGULATORS, PRESSURE RELIEF VALVES, AND VACUUM RELIEF VALVES. OTHER WATER HEATER INSTALLATION REQUIREMENTS. PROTECTION OF PIPING, MATERIALS, AND STRUCTURES.